The Cap 232 kits are great for if you like to fly precision more than 3D.  The Cap has a little less wing area than the Edge 540 so it tracks a little better.  The tail is also somewhat smaller.  The Cap 232 will 3D just fine, but it will roll and loop just like the big ones. 

Cap 232

This kit comes with the very best components for 3D Practice.  As with most of our kits, the CAP 232 is set up for dual aileron servos.  This will allow you to mix the ailerons as needed for flaperon control and differential.  It is strongly recommended that you use a computer radio with the ability to set dual rates and exponential.  With the full flying stab and 70+ degrees of elevator travel, exponential makes flying a lot more fun. 

Kit contents: Complete CAP 232 airframe, precut and glue ready. Sorry, only the standard un-painted airframe is currently available.  Printed instruction booklet.

Combo Components:  Himax 2812-0850 brushless direct drive motor with Castle Creations Thunderbird 18 speed control. 11x4.7 prop. Hitec Micro 05S receiver (or Spectrum 6100) with (4) HS-55 servos. FlightPower 1345, 3 Cell LiPo battery pack with Deans Ultra plug connector. You supply the glue, charger and Transmitter!  

Wing Span: 37", Wing area 355 sq. in., Weight ready to fly 13 oz., Wing loading 5 oz per sq. ft.