Click Here to watch Joe Hunt from Downonthedeck.com wring out the his Fancyfoam Ultimate Bipe  !!!!!!!!!

The Ultimate Bipe is a high performance foamy kit with great slow flight capability. Harriers have no wing rock, just rock solid!  Blenders are awesome. Knife edge is very good with little to no pitching either way.  Inverted flight is in perfect trim with normal flight.  This is a fast building foamy and can do anything you ask of it!!!!!!!     

Now it comes pre-printed or white!!  The bottom of the wings are also printed.

Ultimate 10-300

This kit comes with the very best components for 3D Practice.  As with most of our kits, the Ultimate 10-300 is set up for dual aileron servos.  This will allow you to mix the ailerons as needed for flaperon control and differential.  It is strongly recommended that you use a computer radio with the ability to set dual rates and exponential.  With the full flying stab and 70+ degrees of elevator travel, exponential makes flying a lot more fun. 

Kit contents: Complete Ultimate 10-300 airframe, precut and glue ready (your choice of the standard un-painted airframe or the Deluxe pre-printed airframe for a few dollars more).  Printed instruction booklet,

Combo Contents: Himax 2812-0850 brushless direct drive motor with Castle Creations Thunderbird 18 speed control. 11x4.7 prop. Hitec Micro 05S receiver (or Spectrum 6100) with (4) HS-55 servos. FlightPower 1345, 3 Cell LiPo battery  pack with Deans Ultra plug connector. You supply the glue, charger and Transmitter!  

Wing Span: 32", Wing area 390 sq. in., Weight ready to fly 13 oz., Wing loading 4.5 oz per sq. ft.