|
Vrolet Freestyle V2
"Feather"
This is the Feather version of the Vrolet
Freestyle. Just like the F3P feather, the freetsyle is milled out to
save as much weight as possible.
Fancy Foam Models invented the milled out
"lightened" foamy. We were also the first company to figure out how to
mass produce it. The ENTIRE airframe has been lightened (see photo
below). By milling out the depron, we remove more than an ounce of
weight vs. a normal airframe. The milling will remove the graphics
from the bottom of the wings and one side of the fuselage. Because we remove
so much foam, the airframe is very fragile. This is a high end
competition plane and will not hold up to a mid-air collision or a hard
crash. It will however fly so slow and precise that you'll have an
automatic advantage over the competition.
The printed
version is only 5 grams heavier than a plain white kit. Jason Noll
flew this model to a 4th place finish at the 2007 E-TOC. This kit comes with everything you need to build
and outfit a great flying foamy. This kit is perfect for small
gyms or calm days in your back yard. You'll get flight times of 7 to
10 minutes and extra battery packs are very affordable. Just remember,
the Feather version is much less crash resistant.
Kit Contents:
Complete 3 mm Depron Vrolet V2 kit precut and glue ready. Printed instruction
booklet. Comes with over 25 feet of carbon fiber strips and pushrods, laser
cut plywood control horns, hinge tape, landing gear with wheels, plywood
firewall.
Combo Kit Contents:
AXI 2203-46 outrunner, Thunderbird 9 speed control, FlightPower 350
2 cell - battery,
Hitec Micro receiver with crystal (or Spectrum 6100),
2 E-flight S60 micro servos & one Eflight S75 servo, GWS 8 x 4DD prop, Complete
Vrolet kit precut and glue ready. Printed instruction
booklet. Comes with over 25 feet of carbon fiber strips and pushrods, laser cut plywood
control horns, hinge tape, landing gear with wheels, plywood firewall. (Transmitter Not Included)
Wing Span: 33", Wing area 425 sq. in. Weight ready
to fly 5.0 oz.
|
(Non-milled version shown below)
A close up view of
3 mm Depron milled to less than 1 mm in pocket areas. Another Fancy
Foam Models innovation!
|
